[Docs] [txt|pdf] [Tracker] [WG] [Email] [Diff1] [Diff2] [Nits]

Versions: 00 01 02 03 04 05 06 RFC 3722

Internet Draft                                                Mark Bakke
<draft-ietf-ips-iscsi-string-prep-06.txt>                          Cisco
Standards Track
Expires February 2004

August 2003


                     String Profile for iSCSI Names



Status of this Memo

   This document is an Internet-Draft and is in full conformance with
   all provisions of Section 10 of RFC2026.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF), its areas, and its working groups.  Note that
   other groups may also distribute working documents as Internet-
   Drafts.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet- Drafts as reference
   material or to cite them other than as "work in progress."

   The list of current Internet-Drafts can be accessed at
   http://www.ietf.org/ietf/1id-abstracts.txt

   The list of Internet-Draft Shadow Directories can be accessed at
   http://www.ietf.org/shadow.html.

Copyright Notice

   Copyright (C) The Internet Society (2001).  All Rights Reserved.

Abstract

   The iSCSI protocol provides a way for hosts to access SCSI devices
   over an IP network.  The iSCSI end-points, called initiators and
   targets, each have a globally-unique name that must be transcribable,
   as well as easily compared.

   This document describes how to prepare internationalized iSCSI names
   to increase the likelihood that name input and comparison work in
   ways that make sense for typical users throughout the world.




Bakke                     Expires February 2004                 [Page 1]

Internet Draft       String Profile for iSCSI Names          August 2003


Acknowledgements

   This draft was produced as a result of discussions on iSCSI name
   formats with Joe Czap, Jim Hafner, Howard Hall, Jack Harwood, John
   Hufferd, Marjorie Krueger, Lawrence Lamers, Todd Sperry, Joshua
   Tseng, and Kaladhar Voruganti, as well as discussions on the
   normalization of names into identifiers with Paul Hoffman and Marc
   Blanchet.

   Thanks also to Bob Snively for suggesting the use of the nameprep
   process for iSCSI name normalization.

   Most of this draft was copied from the stringprep profile for
   Internationalized Domain Names [RFC3491], written by Paul Hoffman and
   Marc Blanchet.


1.  Introduction

   The iSCSI protocol [iSCSI] provides a way for hosts to access SCSI
   [SAM2] devices over an IP network.  The iSCSI end-points, called
   initiators and targets, each have a globally-unique name, defined in
   [NDT].

   An iSCSI name is a string of UTF-8 [RFC2044] characters that includes
   a type designator, a naming authority based on domain names, and a
   unique part within the naming authority.  The unique part may be
   generated based on anything the naming authority deems useful, and
   may include user input.

   These names may need to be transcribed (sent between two
   administrators via email, voice, paper, etc), so a case- insensitive
   comparison would be desirable.  However, these names must often be
   compared by initiator and target implementations, most of which are
   done in simple, embedded software.  This makes case-sensitive
   comparison highly desirable for these implementors.

   However, a completely case-sensitive implementation would result in
   identifiers such as "example-name" and "Example-Name" being
   different, which could lead to confusion as these names are
   transcribed.

   The goal, then, is to generate iSCSI names that can be transcribed
   and entered by users, and also compared byte-for-byte, with minimal
   confusion.  To attain these goals, iSCSI names are generalized using
   a normalized character set (converted to lower case or equivalent),
   with no white space allowed, and very limited punctuation.




Bakke                     Expires February 2004                 [Page 2]

Internet Draft       String Profile for iSCSI Names          August 2003


   For those using only ASCII characters (U+0000 to U+007F), the
   following characters are allowed:

   - ASCII dash character ('-' = U+002d)
   - ASCII dot character ('.' = U+002e)
   - ASCII colon character (':' = U+003a)
   - ASCII lower-case characters ('a'..'z' = U+0061..U+007a)
   - ASCII digit characters ('0'..'9' = U+0030..U+0039)

   In addition, any upper-case characters input via a user interface
   should be mapped to their lower-case equivalents.

   This document specifies the valid character set for iSCSI names,
   along with the rules for normalizing and generating iSCSI names based
   on user input or other information that contains international
   characters.

   In particular, it defines the following, as required by [RFC3454]:

   - The intended applicability of the profile: internationalized iSCSI
     names.

   - The character repertoire that is the input and output to
     stringprep: Unicode 3.2, specified in section 3.

   - The mappings used: specified in section 4.

   - The Unicode normalization used: specified in section 5.

   - The characters that are prohibited as output: specified in section
     6.

   This profile MUST be used with the iSCSI protocol.


2.  Terminology

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in [RFC2119].

   Examples in this document use the notation for code points and names
   from the Unicode Standard [Unicode3.2] and ISO/IEC 10646 [ISO10646].
   For example, the letter "a" may be represented as either "U+0061" or
   "LATIN SMALL LETTER A". In the lists of prohibited characters, the
   "U+" is left off to make the lists easier to read. The comments for
   character ranges are shown in square brackets (such as "[SYMBOLS]")
   and do not come from the standards.



Bakke                     Expires February 2004                 [Page 3]

Internet Draft       String Profile for iSCSI Names          August 2003


3.  Character Repertoire

   This profile uses Unicode 3.2, as defined in [RFC3454] Appendix A.


4.  Mapping

   This profile specifies mapping using the following tables from
   [RFC3454].  The following mapping tables MUST be used when generating
   iSCSI names from Unicode characters.

      Table B.1
      Table B.2


5.  Normalization

   Unicode normalization form KC MUST be used with this profile, as
   described in [RFC3454].


6.  Prohibited Output

   This profile specifies prohibiting using the following tables from
   [stringprep].  Characters appearing within these tables MUST NOT be
   used within an iSCSI name.

      Table C.1.1
      Table C.1.2
      Table C.2.1
      Table C.2.2
      Table C.3
      Table C.4
      Table C.5
      Table C.6
      Table C.7
      Table C.8
      Table C.9

   Important note: this profile MUST be used with the iSCSI protocol.
   The iSCSI protocol has additional naming rules that are checked
   outside of this profile.

   In addition, this profile adds the following prohibitions.  The full
   set of prohibited characters are those from the tables above plus
   those listed individually below.





Bakke                     Expires February 2004                 [Page 4]

Internet Draft       String Profile for iSCSI Names          August 2003


6.1.  Inappropriate Characters from Common Input Mechanisms

   u+3002 is used as if it were u+002e in many domain name input
   mechanisms used by applications, particularly in Asia.  The character
   u+3002 MUST NOT be used in an iSCSI name.

      3002; ideographic full stop


6.2.  Currently-prohibited ASCII characters

   Some of the ASCII characters that are currently prohibited in iSCSI
   names by [NDT] are also used in protocol elements such as URIs.  Some
   examples are described in [RFC2396] and [RFC2732].  Note that there
   are many other RFCs that define additional URI schemes.

   The other characters in the range U+0000 to U+007F that are not
   currently allowed are prohibited in iSCSI names to reserve them for
   future use in protocol elements.  Note that the dash (U+002D), dot
   (U+002E), and colon (U+003A) are not prohibited.

   The following characters MUST NOT be used in iSCSI names:

      0000-002C; [ASCII CONTROL CHARACTERS and SPACE through ,]
      002F; [ASCII /]
      003B-0040; [ASCII ; through @]
      005B-0060; [ASCII [ through `]
      007B-007F; [ASCII { through DEL]


7.  Bidirectional Characters

   This profile specifies checking bidirectional strings as described in
   [RFC3454] section 6.


8.  Unassigned Code Points in Internationalized Domain Names

   If the processing in [iSCSI] specifies that a list of unassigned code
   points be used, the system uses table A.1 from [RFC3454] as its list
   of unassigned code points.


9.  Security Considerations

   ISO/IEC 10646 has many characters that look similar. In many cases,
   users of security protocols might do visual matching, such as when
   comparing the names of trusted third parties. This profile does



Bakke                     Expires February 2004                 [Page 5]

Internet Draft       String Profile for iSCSI Names          August 2003


   nothing to map similar-looking characters together.

   iSCSI names may be used by an initiator to verify that a target it
   has discovered is the correct one, and by a target to verify that an
   initiator is to be allowed access.  If these names are interpreted
   and compared differently by different iSCSI implementations, an
   initiator could gain access to the wrong target, or could be denied
   access to a legitimate target.


10.  IANA Considerations

   This is a profile of stringprep. When it has been reviewed and
   approved by the IESG, it should be registered in the IANA "Stringprep
   Profiles" registry.  This process is described in the IANA
   Considerations section of [RFC3454].


11.  Summary

   This document describes a stringprep profile to be used with programs
   generating names for iSCSI initiators and targets.


12.  Normative References


[RFC2119]   Scott Bradner, "Key words for use in RFCs to Indicate
            Requirement Levels", RFC 2119, March 1997.

[RFC3454]   Paul Hoffman and Marc Blanchet, "Preparation of
            Internationalized Strings ("stringprep")", RFC 3454,
            December 2002.

[iSCSI]     J. Satran, et. al.  "iSCSI", Work In Progress, draft-ietf-
            ips-iscsi-20.txt, January 2003.


13.  Informative References


[NDT]       K. Voruganti, et. al.  "iSCSI Naming and Discovery", Work in
            Progress, draft-ietf-ips-iscsi-name-disc-09, March 2003.

[RFC3491]   P. Hoffman and M. Blanchet, "Nameprep: A Stringprep Profile
            for Internationalized Domain Names", RFC 3491, March 2003.





Bakke                     Expires February 2004                 [Page 6]

Internet Draft       String Profile for iSCSI Names          August 2003


[SAM2]      ANSI T10.  "SCSI Architectural Model 2", March 2000.

[RFC2044]   F. Yergeau, "UTF-8, a transformation format of Unicode and
            ISO 10646", RFC 2044, October 1996.

[RFC2396]   T. Berners-Lee, R. Fielding, L. Masinter, "Uniform Resource
            Identifiers", RFC 2396, August 1998.

[RFC2732]   R. Hindon, B. Carpenter, L Masinter, "Format for Literal
            IPv6 Addresses in URLs", RFC 2732, December 1999.

[Unicode3.2]
            The Unicode Standard, Version 3.2.0: The Unicode Consortium.
            The Unicode Standard, Version 3.2.0 is defined by The
            Unicode Standard, Version 3.0 (Reading, MA, Addison-Wesley,
            2000. ISBN 0-201-61633-5), as amended by the Unicode
            Standard Annex #27: Unicode 3.1
            (http://www.unicode.org/unicode/reports/tr27/) and by the
            Unicode Standard Annex #28: Unicode 3.2
            (http://www.unicode.org/unicode/reports/tr28/).

[ISO10646]  ISO/IEC 10646-1:2000. International Standard -- Information
            technology -- Universal Multiple-Octet Coded Character Set
            (UCS) -- Part 1: Architecture and Basic Multilingual Plane.


14.  Author Contact Information

       Mark Bakke
       Cisco Systems, Inc.
       6450 Wedgwood Road
       Maple Grove, MN
       USA 55311

       Voice:  +1 763-398-1000
       E-Mail: mbakke@cisco.com


15.  Full Copyright Notice

   Copyright (C) The Internet Society (2001).  All Rights Reserved.

   This document and translations of it may be copied and furnished to
   others, and derivative works that comment on or otherwise explain it
   or assist in its implementation may be prepared, copied, published
   and distributed, in whole or in part, without restriction of any
   kind, provided that the above copyright notice and this paragraph are
   included on all such copies and derivative works.  However, this



Bakke                     Expires February 2004                 [Page 7]

Internet Draft       String Profile for iSCSI Names          August 2003


   document itself may not be modified in any way, such as by removing
   the copyright notice or references to the Internet Society or other
   Internet organizations, except as needed for the purpose of
   developing Internet standards in which case the procedures for
   copyrights defined in the Internet Standards process must be
   followed, or as required to translate it into languages other than
   English.

   The limited permissions granted above are perpetual and will not be
   revoked by the Internet Society or its successors or assigns.

   This document and the information contained herein is provided on an
   "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
   TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
   BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
   HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
   MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.





























Bakke                     Expires February 2004                 [Page 8]


Html markup produced by rfcmarkup 1.108, available from http://tools.ietf.org/tools/rfcmarkup/