[Docs] [txt|pdf] [Tracker] [Email] [Nits]

Versions: 00 01 02

Network Working Group                                      Alvaro Retana
Internet Draft                                                Russ White
Expiration Date: April 2003                          Cisco Systems, Inc.
File name: draft-retana-bgp-custom-decision-00.txt          October 2002

                      BGP Custom Decision Process
                draft-retana-bgp-custom-decision-00.txt

Status of this Memo

   This document is an Internet-Draft and is in full conformance with
   all provisions of Section 10 of RFC2026.

   Internet Drafts are working documents of the Internet Engineering
   Task Force (IETF), its Areas, and its Working Groups. Note that other
   groups may also distribute working documents as Internet Drafts.

   Internet Drafts are draft documents valid for a maximum of six
   months.  Internet Drafts may be updated, replaced, or obsoleted by
   other documents at any time. It is not appropriate to use Internet
   Drafts as reference material or to cite them other than as a "working
   draft" or "work in progress".

   The list of current Internet-Drafts can be accessed at
   http://www.ietf.org/ietf/1id-abstracts.txt

   The list of Internet-Draft Shadow Directories can be accessed at
   http://www.ietf.org/shadow.html.

Abstract

   The BGP specification [RFC1771] defines a Decision Process for
   installation of routes into the Loc-RIB.  This process takes into
   account an extensive series of path attributes, which can be
   manipulated to indicate preference for specific paths.  It is
   cumbersome (if at all possible) for the end user to define policies
   that will select, after partial comparison, a path based on
   subjective local (domain and/or node) criteria.

   This document defines a new Extended Community [EXT_COMM], called the
   Cost Community, which may be used in tie breaking during the best
   path selection process.  The end result is a local custom decision
   process.








Retana and White                                                [Page 1]

INTERNET DRAFT        BGP Custom Decision Process           October 2002


1. Introduction

   There are a number of metrics available within the BGP decision
   process [RFC1771] which can be used to determine the exit point for
   traffic, but there is no metric, or combination of metrics, which can
   be used to break a tie among generally equal paths.

   o    LOCAL_PREF: The LOCAL_PREF is an absolute tie breaker near the
        beginning of the decision process. There is no way to configure
        the LOCAL_PREF such that the MED, IGP metric, and other metrics
        are considered before breaking a tie.

   o    MED: The MULTI_EXIT_DISC is an indicator of which local entrance
        point an AS would like a peering AS to use; MED isn't suitable
        to break the tie between two equal cost paths learned from two
        peer ASes. MED is also compared before the IGP metric; there is
        no way to set the MED so a path with a higher IGP metric is pre-
        ferred over a path with a lower IGP metric.

   o    IGP Metric: It is possible, using the IGP metric, to influence
        individual paths with otherwise equal cost metrics, but only by
        changing the next hop towards each path, and configuring the IGP
        costs of reaching each next hop. This method is cumbersome, and
        prone to confusion and error.


2. Specification of Requirements

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in [RFC2119].


3. The BGP Cost Community

   The BGP Cost Community is an Opaque Extended Community [EXT_COMM]
   defined as follows:

      Type Field:

         The value of the high-order octet of the extended Type Field is
         0x43, which indicates it is non-transitive. The value of the
         low-order octet of the extended type field for this community
         is TBD.

      Value Field

         The Value field contains three distinct sub-fields, described



Retana and White                                                [Page 2]

INTERNET DRAFT        BGP Custom Decision Process           October 2002


         below:

                        +------------------------------+
                        | Point of Insertion (1 octet) |
                        +------------------------------+
                        | Community-ID (1 octet)       |
                        +------------------------------+
                        | Cost (4 octets)              |
                        +------------------------------+

            The Point of Insertion sub-field contains the value of the
            path attribute [BGP_PAR] *after* which this community MUST
            be considered during the best path selection process.

               The BGP decision process [RFC1771] includes some steps
               that do not correspond to any path attribute; the follow-
               ing values are defined:

               Value          Meaning

               128
                    ABSOLUTE_VALUE - Indicates that the Cost Community
                    MUST be considered as the first step in determining
                    the Degree of Preference of a path.

               129
                    IGP_COST - Indicates that the Cost Community MUST be
                    considered after the interior (IGP) distance to the
                    next-hop has been compared.

               130
                    EXTERNAL_INTERNAL - Indicates that the Cost Commun-
                    ity MUST be considered after the paths advertised by
                    BGP speakers in a neighbouring autonomous system (if
                    any) have been selected.

               131
                    BGP_ID - Indicates that the Cost Community MUST be
                    considered after the BGP Identifier (or
                    ORIGINATOR_ID [RFC2796]) has been compared.

            The Community-ID sub-field contains an identifier to distin-
            guish between multiple instances of the Cost Community.

            The Cost sub-field contains a value assigned by the network
            administrator and that is significant to the local auto-
            nomous system.  The lower cost MUST be preferred.  The
            default value is 0x7FFFFFFF (half the maximum value).



Retana and White                                                [Page 3]

INTERNET DRAFT        BGP Custom Decision Process           October 2002


4. Operation

   The network administrator may use the Cost Community to assign a
   value to a path originated or learned by a peer in any part of the
   local domain. The Point of Insertion may also be specified using the
   values defined in the IANA registry [BGP_PAR] or this document.

   If a BGP speaker receives a path that contains the Cost Community, it
   MUST consider its value at the Point of Insertion specified, when
   calculating the best path [RFC1771].

   If the Point of Insertion is not valid for the local best path selec-
   tion implementation, then the Cost Community is silently ignored.
   Paths that do not contain the Cost Community (for a valid, particular
   Point of Insertion) are considered to have the default value.

   Multiple Cost Communities may indicate the same Point of Insertion.
   In this case, the Cost Community with the lowest Community-ID is con-
   sidered first.  In other words, all the Cost Communities for a
   specific Point of Insertion are considered, starting with the one
   with the lowest Community-ID.

   If a range of routes is to be aggregated and the resultant aggregates
   path attributes do not carry the ATOMIC_AGGREGATE attribute, then the
   resulting aggregate should have an Extended Communities path attri-
   bute which contains the set union of all the Cost Communities from
   all of the aggregated routes.  If multiple Cost Communities for the
   same Point of Insertion (and with the same Community-ID), then only
   the ones with the highest Cost SHOULD be included.

   The Cost Community is a non-transitive Extended Community [EXT_COMM].
   If a Cost Community is received across an Autonomous System boundary,
   then the receiver SHOULD strip it off the BGP update, and ignore it
   when running the selection process.


4.1. Deployment Considerations

   The mechanisms described in this document may be used to modify the
   BGP path selection process arbitrarily, within an AS.  It is impor-
   tant that a consistent path selection process be maintained across
   the local Autonomous System to avoid potential routing loops.  In
   other words, if the Cost Community is used, all the nodes in the AS
   that may have to consider this new community at any Point of Inser-
   tion SHOULD be aware of the mechanisms described in this document.






Retana and White                                                [Page 4]

INTERNET DRAFT        BGP Custom Decision Process           October 2002


5. IANA Considerations

   The section titled "The BGP Cost Community" defines a series of
   values to be used to indicate steps in the best path selection pro-
   cess [RFC1771] that do not map directly to a path attribute. IANA is
   expected to maintain the registry for these values.  Values 128
   through 191 are to be assigned by IANA using the "IETF Consensus"
   policy defined in RFC2434 [RFC2434]. Values 192 through 254 are for
   "Private Use" as defined in RFC2434 [RFC2434].

   The Value space defined above matches the one already used and main-
   tained by IANA to assign BGP path attributes [BGP_PAR].  It is RECOM-
   MENDED that the values specified in this document are added to the
   current registry [BGP_PAR] and the process to register new attributes
   be updated [RFC2042].


6. Security Considerations

   This document introduces no new security concerns to BGP or other
   specifications referenced in this document.


7. Acknowledgments

   We would like to thank Chris Whyte, Khamsa Enaya, John Scudder, Tom
   Barron, Eric Rosen, Barry Friedman, Gargi Nalawade, Ruchi Kapoor and
   Chandra Appanna for their comments and suggestions.  We would like to
   also thank Dan Tappan for the Opaque Extended Community type.


8. References

 [RFC1771]
      Rekhter, Y., and T. Li, "A Border Gateway Protocol 4 (BGP-4)", RFC
      1771, March 1995.

 [EXT_COMM]
      Sangli, S., Tappan, D., and Rekhter, Y., "BGP Extended Communities
      Attribute", Work in Progress (draft-ietf-idr-bgp-ext-communities-
      05.txt), May 2002.

 [RFC2119]
      Bradner, S., "Key words for use in RFCs to Indicate Requirement
      Levels", RFC 2119, March 1997.

 [BGP_PAR]
      Internet Assigned Numbers Authority, "BGP Parameters",



Retana and White                                                [Page 5]

INTERNET DRAFT        BGP Custom Decision Process           October 2002


      http://www.iana.org/assignments/bgp-parameters.

 [RFC2796]
      Bates, T., Chandra, R., and Chen, E., "BGP Route Reflection - An
      Alternative to Full Mesh IBGP", RFC 2796, April 2000.

 [RFC2434]
      Narten, T., Alvestrand, H., "Guidelines for Writing an IANA Con-
      siderations Section in RFCs", RFC 2434, October 1998.

 [RFC2042]
      Manning, B., "Registering New BGP Attribute Types", RFC 2042,
      January 1997.


9. Authors' Addresses

      Alvaro Retana
      Cisco Systems, Inc.
      7025 Kit Creek Rd.
      Research Triangle Park, NC 27709
      Email: aretana@cisco.com

      Russ White
      Cisco Systems, Inc.
      7025 Kit Creek Rd.
      Research Triangle Park, NC 27709
      Email: riw@cisco.com























Retana and White                                                [Page 6]


Html markup produced by rfcmarkup 1.107, available from http://tools.ietf.org/tools/rfcmarkup/