[Docs] [txt|pdf|xml] [Tracker] [WG] [Email] [Diff1] [Diff2] [Nits]

Versions: (draft-grmas-bfd-rfc5884-clarifications) 00 01 02 03 04 RFC 7726

Internet Engineering Task Force                              V. Govindan
Internet-Draft                                              K. Rajaraman
Updates: 5884 (if approved)                                Cisco Systems
Intended status: Standards Track                               G. Mirsky
Expires: April 16, 2016                                         Ericsson
                                                                N. Akiya
                                                     Big Switch Networks
                                                               S. Aldrin
                                                                  Google
                                                        October 14, 2015


                       Clarifications to RFC 5884
                draft-ietf-bfd-rfc5884-clarifications-04

Abstract

   This document clarifies the procedures for establishing, maintaining
   and removing multiple, concurrent BFD (Bidirectional Forwarding
   Detection) sessions for a given <MPLS LSP, FEC> described in RFC5884.

Status of This Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at http://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on April 16, 2016.

Copyright Notice

   Copyright (c) 2015 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect



Govindan, et al.         Expires April 16, 2016                 [Page 1]


Internet-Draft         Clarifications to RFC 5884           October 2015


   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Table of Contents

   1.  Background  . . . . . . . . . . . . . . . . . . . . . . . . .   2
     1.1.  Requirements Language . . . . . . . . . . . . . . . . . .   2
   2.  Theory of Operation . . . . . . . . . . . . . . . . . . . . .   3
     2.1.  Procedures for establishment of multiple BFD sessions . .   3
     2.2.  Procedures for maintenance of multiple BFD sessions . . .   4
     2.3.  Procedures for removing BFD sessions at the egress LSR  .   4
     2.4.  Changing discriminators for a BFD session . . . . . . . .   5
   3.  Backwards Compatibility . . . . . . . . . . . . . . . . . . .   5
   4.  Security Considerations . . . . . . . . . . . . . . . . . . .   5
   5.  IANA Considerations . . . . . . . . . . . . . . . . . . . . .   5
   6.  Acknowledgements  . . . . . . . . . . . . . . . . . . . . . .   5
   7.  Normative References  . . . . . . . . . . . . . . . . . . . .   6
   Authors' Addresses  . . . . . . . . . . . . . . . . . . . . . . .   6

1.  Background

   [RFC5884] defines the procedures to bootstrap and maintain BFD
   sessions for a <MPLS FEC, LSP> using LSP ping.  While Section 4 of
   [RFC5884] specifies that multiple BFD sessions can be established for
   a <MPLS FEC, LSP> tuple, the procedures to bootstrap and maintain
   multiple BFD sessions concurrently over a <MPLS FEC, LSP> are not
   clearly specified.  Additionally, the procedures of removing BFD
   sessions bootstrapped on the egress LSR are unclear.  This document
   provides those clarifications without deviating from the principles
   outlined in [RFC5884].

   The ability for an ingress LSR to establish multiple BFD sessions for
   a <MPLS FEC, LSP> tuple is useful in scenarios such as Segment
   Routing based LSPs or LSPs having Equal-Cost Multipath (ECMP).  The
   process used by the ingress LSR to determine the number of BFD
   session(s) to be bootstrapped for a <MPLS FEC, LSP> tuple and the
   mechanism of constructing those session(s) are outside the scope of
   this document.

1.1.  Requirements Language

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and
   "OPTIONAL" in this document are to be interpreted as described in
   [RFC2119].




Govindan, et al.         Expires April 16, 2016                 [Page 2]


Internet-Draft         Clarifications to RFC 5884           October 2015


2.  Theory of Operation

2.1.  Procedures for establishment of multiple BFD sessions

   Section 4 of [RFC5884] specifies the procedure for bootstrapping BFD
   sessions using LSP ping.  It further states that "a BFD session
   SHOULD be established for each alternate path that is discovered".
   This requirement has been the source of some ambiguity as the
   procedures of establishing concurrent, multiple sessions have not
   been explicitly specified.  This ambiguity can also be attributed in
   part to the text in Section 7 of [RFC5884] forbidding either end to
   change local discriminator values in BFD control packets after the
   session reaches the UP state.  The following procedures are described
   to clarify the ambiguity based on the interpretation of the authors's
   reading of the referenced sections:

   At the ingress LSR:

      MPLS LSP ping can be used to bootstrap multiple BFD sessions for a
      given <MPLS FEC, LSP>.  Each LSP ping MUST carry a different
      discriminator value in the BFD discriminator TLV [RFC4379].

   The egress LSR needs to perform the following:

      If the validation of the FEC in the MPLS Echo request message
      succeeds, check the discriminator specified in the BFD
      discriminator TLV of the MPLS Echo request.  If there is no local
      session that corresponds to the (remote) discriminator received in
      the MPLS Echo request, a new session is bootstrapped and a local
      discriminator is allocated.  The validation of a FEC is a
      necessary condition to be satisfied to create a new BFD session at
      the egress LSR.  However, the policy or procedure if any, to be
      applied by the egress LSR before allowing a new BFD session to be
      created is outside the scope of this document.  Such policies or
      procedures could consider availability of system resources before
      allowing a session to be created.  When the egress LSR disallows
      the creation of a BFD session due to policy, it MUST drop the MPLS
      Echo request message.

      Ensure the uniqueness of the <MPLS FEC, LSP, Remote
      Discriminiator> tuple.

      Except for the clarification mentioned above, the remaining
      procedures ofBFD session establishment are as specified in
      Sections 4-6 of [RFC5884].






Govindan, et al.         Expires April 16, 2016                 [Page 3]


Internet-Draft         Clarifications to RFC 5884           October 2015


2.2.  Procedures for maintenance of multiple BFD sessions

   Both the ingress LSR and egress LSR use the YourDiscriminator of the
   received BFD packet to demultiplex BFD sessions.

2.3.  Procedures for removing BFD sessions at the egress LSR

   [RFC5884] does not specify an explicit procedure for deleting BFD
   sessions.  The procedure for removing a BFD session established by an
   out-of-band discriminator exchange using the MPLS LSP ping can
   improve resource management (like memory etc.) especially in
   scenarios involving thousands or more of such sessions.  A few
   observations are made here:

      The BFD session MAY be removed in the egress LSR if the BFD
      session transitions from UP to DOWN.  This can either be done
      immediately after the BFD session transitions from UP to DOWN or
      after the expiry of a configurable timer started after the BFD
      session state transitions from UP to DOWN at the egress LSR to
      reduce flapping by adding hysteresis.

      The BFD session on the egress LSR MAY be removed by the ingress
      LSR by using the BFD diagnostic code AdminDown(7) as specified in
      [RFC5880].  When the ingress LSR wants to remove a session without
      triggering any state change at the egress, it MAY transmit BFD
      packets indicating the State as Down(1), diagnostic code
      AdminDown(7) detectMultiplier number of times.  Upon receiving
      such a packet, the egress LSR MAY remove the BFD session, without
      triggering a change of state.

      The procedures to be followed at the egress LSR when BFD
      session(s) remain in the DOWN state for a significant amount of
      time is a local matter.  Such procedures are outside the scope of
      this document.

      All BFD sessions established with the FEC MUST be removed
      automatically if the FEC is removed.

      The egress MUST use the discriminators exchanged when the session
      was brought UP, to indicate any session state change to the
      ingress.  The egress SHOULD reset this to zero after transmitting
      bfd.detectMult number of packets if the BFD session transitions to
      DOWN state.








Govindan, et al.         Expires April 16, 2016                 [Page 4]


Internet-Draft         Clarifications to RFC 5884           October 2015


2.4.  Changing discriminators for a BFD session

   The discriminators of a BFD session established over an MPLS LSP
   cannot be changed when it is in UP state.  The BFD session could be
   removed after a graceful transition to AdminDown state using the BFD
   diagnostic code AdminDown.  A new session could be established with a
   different discriminator.  The initiation of the transition from the
   Up to Down state can be done either by the ingress LSR or the egress
   LSR.

3.  Backwards Compatibility

   The procedures clarified by this document are fully backward
   compatible with an existing implementation of [RFC5884].  While the
   capability to bootstrap and maintain multiple BFD sessions may not be
   present in current implementations, the procedures outlined by this
   document can be implemented as a software upgrade without affecting
   existing sessions.  In particular, the egress LSR needs to support
   multiple BFD sessions per <MPLS FEC, LSP> before the ingress LSR is
   upgraded.

4.  Security Considerations

   This document clarifies the mechanism to bootstrap multiple BFD
   sessions per <MPLS FEC, LSP>.  BFD sessions, naturally, use system
   and network resources.  More BFD sessions means more resources will
   be used.  It is highly important to ensure only minimum number of BFD
   sessions are provisioned per FEC, and bootstrapped BFD sessions are
   properly deleted when no longer required.  Additionally security
   measures described in [RFC4379] and [RFC5884] are to be followed.

5.  IANA Considerations

   This document does not make any requests to IANA.

6.  Acknowledgements

   The authors would like to thank Marc Binderberger for performing
   thorough reviews and providing valuable suggestions.

   The authors would like to thank Mudigonda Mallik, Rajaguru Veluchamy
   and Carlos Pignataro of Cisco Systems for their review comments.

   The authors would like to thank Alvaro Retana and Scott Bradner for
   their review comments.






Govindan, et al.         Expires April 16, 2016                 [Page 5]


Internet-Draft         Clarifications to RFC 5884           October 2015


7.  Normative References

   [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
              Requirement Levels", BCP 14, RFC 2119,
              DOI 10.17487/RFC2119, March 1997,
              <http://www.rfc-editor.org/info/rfc2119>.

   [RFC4379]  Kompella, K. and G. Swallow, "Detecting Multi-Protocol
              Label Switched (MPLS) Data Plane Failures", RFC 4379,
              DOI 10.17487/RFC4379, February 2006,
              <http://www.rfc-editor.org/info/rfc4379>.

   [RFC5880]  Katz, D. and D. Ward, "Bidirectional Forwarding Detection
              (BFD)", RFC 5880, DOI 10.17487/RFC5880, June 2010,
              <http://www.rfc-editor.org/info/rfc5880>.

   [RFC5884]  Aggarwal, R., Kompella, K., Nadeau, T., and G. Swallow,
              "Bidirectional Forwarding Detection (BFD) for MPLS Label
              Switched Paths (LSPs)", RFC 5884, DOI 10.17487/RFC5884,
              June 2010, <http://www.rfc-editor.org/info/rfc5884>.

Authors' Addresses

   Vengada Prasad Govindan
   Cisco Systems

   Email: venggovi@cisco.com


   Kalyani Rajaraman
   Cisco Systems

   Email: kalyanir@cisco.com


   Gregory Mirsky
   Ericsson

   Email: gregory.mirsky@ericsson.com


   Nobo Akiya
   Big Switch Networks

   Email: nobo.akiya.dev@gmail.com






Govindan, et al.         Expires April 16, 2016                 [Page 6]


Internet-Draft         Clarifications to RFC 5884           October 2015


   Sam Aldrin
   Google

   Email: aldrin.ietf@gmail.com















































Govindan, et al.         Expires April 16, 2016                 [Page 7]


Html markup produced by rfcmarkup 1.127, available from https://tools.ietf.org/tools/rfcmarkup/