[Docs] [txt|pdf|xml] [Tracker] [WG] [Email] [Diff1] [Diff2] [Nits]

Versions: (draft-mauch-bgp-reject) 00 01 02 03 04 05 06 07 08

Global Routing Operations                                       J. Mauch
Internet-Draft                                                    Akamai
Updates: 4271 (if approved)                                  J. Snijders
Intended status: Standards Track                                     NTT
Expires: November 25, 2017                                    G. Hankins
                                                                   Nokia
                                                            May 24, 2017


        Default EBGP Route Propagation Behavior Without Policies
                     draft-ietf-grow-bgp-reject-08

Abstract

   This document updates RFC4271 by defining the default behavior of a
   BGP speaker when there is no Import or Export Policy associated with
   an External BGP session.

Requirements Language

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in RFC 2119 [RFC2119].

Status of This Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at http://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on November 25, 2017.

Copyright Notice

   Copyright (c) 2017 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents



Mauch, et al.           Expires November 25, 2017               [Page 1]


Internet-Draft             BGP Default Reject                   May 2017


   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   2
   2.  Terminology . . . . . . . . . . . . . . . . . . . . . . . . .   3
   3.  Changes to RFC4271  . . . . . . . . . . . . . . . . . . . . .   3
   4.  Acknowledgments . . . . . . . . . . . . . . . . . . . . . . .   4
   5.  Security Considerations . . . . . . . . . . . . . . . . . . .   4
   6.  IANA Considerations . . . . . . . . . . . . . . . . . . . . .   4
   7.  Contributors  . . . . . . . . . . . . . . . . . . . . . . . .   4
   8.  References  . . . . . . . . . . . . . . . . . . . . . . . . .   5
     8.1.  Normative References  . . . . . . . . . . . . . . . . . .   5
     8.2.  Informative References  . . . . . . . . . . . . . . . . .   5
   Appendix A.  Transition Considerations for BGP Implementers . . .   5
     A.1.  "N+1 N+2" Release Strategy  . . . . . . . . . . . . . . .   5
   Authors' Addresses  . . . . . . . . . . . . . . . . . . . . . . .   6

1.  Introduction

   BGP routing security issues need to be addressed in order to make the
   Internet more stable.  Route leaks [RFC7908] are part of the problem,
   but software defects or operator misconfiguration can contribute too.
   This document updates [RFC4271] so that routes are neither imported
   nor exported unless specifically enabled by configuration.  This
   change reduces the consequences of these problems, and improves the
   default level of Internet routing security.

   Many deployed BGP speakers send and accept any and all route
   announcements between their BGP neighbors by default.  This practice
   dates back to the early days of the Internet, where operators were
   permissive in sending routing information to allow all networks to
   reach each other.  As the Internet has become more densely
   interconnected, the risk of a misbehaving BGP speaker poses
   significant risks to Internet routing.

   This specification intends to improve this situation by requiring the
   explicit configuration of both BGP Import and Export Policies for any
   External BGP (EBGP) session such as customers, peers, or
   confederation boundaries for all enabled address families.  Through
   codification of the aforementioned requirement, operators will




Mauch, et al.           Expires November 25, 2017               [Page 2]


Internet-Draft             BGP Default Reject                   May 2017


   benefit from consistent behaviour across different BGP
   implementations.

   BGP speakers following this specification do not use or send routes
   on EBGP sessions, unless specifically configured to do so.

2.  Terminology

   [RFC4271] describes a Policy Information Base (PIB) which contains
   local policies that can be applied to the information in the Routing
   Information Base (RIB).  This document distinguishes the type of a
   policy based on its application.

   Import Policy: a local policy to be applied to the information
   contained in the Adj-RIBs-In.  As described in Section 3.2 [RFC4271],
   the Adj-RIBs-In contain information learned from other BGP speakers,
   and the application of the Import Policy results in the routes that
   will be considered in the Decision Process by the local BGP speaker.

   Export Policy: a local policy to be applied in selecting the
   information contained in the Adj-RIBs-Out.  As described in
   Section 3.2 [RFC4271], the Adj-RIBs-Out contain information that has
   been selected for advertisement to other BGP speakers.

3.  Changes to RFC4271

   This section updates [RFC4271] to specify the default behavior of a
   BGP speaker when there are no Import or Export Policies associated
   with a particular EBGP session.  A BGP speaker MAY provide a
   configuration option to deviate from the following updated behaviors.

   The following paragraph is added to Section 9.1 (Decision Process)
   after the fifth paragraph, which ends in "route aggregation and route
   information reduction":

      Routes contained in an Adj-RIB-In associated with an EBGP peer
      SHALL NOT be considered eligible in the Decision Process if no
      explicit Import Policy has been applied.

   The following paragraph is added to Section 9.1.3 (Phase 3: Route
   Dissemination) after the third paragraph, which ends in "by means of
   an UPDATE message (see 9.2).":

      Routes SHALL NOT be added to an Adj-RIB-Out associated with an
      EBGP peer if no explicit Export Policy has been applied.






Mauch, et al.           Expires November 25, 2017               [Page 3]


Internet-Draft             BGP Default Reject                   May 2017


4.  Acknowledgments

   The authors would like to thank the following people for their
   comments, support and review: Shane Amante, Christopher Morrow,
   Robert Raszuk, Greg Skinner, Adam Chappell, Sriram Kotikalapudi,
   Brian Dickson, Jeffrey Haas, John Heasley, Ignas Bagdonas, Donald
   Smith, Dale Worley, Alvaro Retana, John Scudder, and Dale Worley.

5.  Security Considerations

   Permissive default routing policies can result in inadvertent effects
   such as route leaks [RFC7908], in general resulting in routing of
   traffic through an unexpected path.  While it is possible for an
   operator to use monitoring to detect unexpected flows, there is no
   general framework that can be applied.  These policies also have the
   potential to expose software defects or misconfiguration that could
   have unforeseen technical and business impacting effects.

   The update to [RFC4271] specified in this document is intended to
   eliminate those inadvertent effects.  Operators must explicitly
   configure Import and Export Policies to achieve their expected goals.
   There is of course no protection against a malicious or incorrect
   explicit configuration.

   The security considerations described in [RFC4271] and the
   vulnerability analysis discussed in [RFC4272] also apply to this
   document.

6.  IANA Considerations

   This document has no actions for IANA.

7.  Contributors

   The following people contributed to successful deployment of solution
   described in this document:

   Jakob Heitz
   Cisco

   Email: jheitz@cisco.com

   Ondrej Filip
   CZ.NIC

   Email: ondrej.filip@nic.cz





Mauch, et al.           Expires November 25, 2017               [Page 4]


Internet-Draft             BGP Default Reject                   May 2017


8.  References

8.1.  Normative References

   [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
              Requirement Levels", BCP 14, RFC 2119,
              DOI 10.17487/RFC2119, March 1997,
              <http://www.rfc-editor.org/info/rfc2119>.

   [RFC4271]  Rekhter, Y., Ed., Li, T., Ed., and S. Hares, Ed., "A
              Border Gateway Protocol 4 (BGP-4)", RFC 4271,
              DOI 10.17487/RFC4271, January 2006,
              <http://www.rfc-editor.org/info/rfc4271>.

8.2.  Informative References

   [RFC4272]  Murphy, S., "BGP Security Vulnerabilities Analysis",
              RFC 4272, DOI 10.17487/RFC4272, January 2006,
              <http://www.rfc-editor.org/info/rfc4272>.

   [RFC7908]  Sriram, K., Montgomery, D., McPherson, D., Osterweil, E.,
              and B. Dickson, "Problem Definition and Classification of
              BGP Route Leaks", RFC 7908, DOI 10.17487/RFC7908, June
              2016, <http://www.rfc-editor.org/info/rfc7908>.

Appendix A.  Transition Considerations for BGP Implementers

   This appendix is non-normative.

   For an implementer, transitioning to a compliant BGP implementation
   may require a process that can take several years.

   It is understood and acknowledged that operators who are taking
   advantage of an undefined behavior will always be surprised by
   changes to said behavior.

A.1.  "N+1 N+2" Release Strategy

   An implementer could leverage an approach described as the "N+1 and
   N+2" release strategy.  In release N+1, the implementer introduces a
   new default configuration parameter to indicate that the BGP speaker
   is operating in "ebgp insecure-mode".  In addition to the
   introduction of the new parameter, an implementer could begin to
   display informational warnings to the operator that certain parts of
   the configuration are incomplete.  In release N+1, operators of the
   BGP implementation become aware that a configurable default exists in
   the implementation, and can prepare accordingly.  In release N+2 or




Mauch, et al.           Expires November 25, 2017               [Page 5]


Internet-Draft             BGP Default Reject                   May 2017


   later, the inverse of the previous default configuration parameter
   that was introduced in release N+1 becomes the new default.

   As a result, any new installation of release N+2 will adhere to this
   document.  Installations upgraded from version release N+1 will
   adhere to the previous insecure behavior, if no modification was made
   to the "ebgp insecure-mode" configuration parameter.

Authors' Addresses

   Jared Mauch
   Akamai Technologies
   8285 Reese Lane
   Ann Arbor  Michigan 48103
   US

   Email: jared@akamai.com


   Job Snijders
   NTT Communications
   Theodorus Majofskistraat 100
   Amsterdam  1065 SZ
   NL

   Email: job@ntt.net


   Greg Hankins
   Nokia
   777 E. Middlefield Road
   Mountain View, CA  94043
   USA

   Email: greg.hankins@nokia.com
















Mauch, et al.           Expires November 25, 2017               [Page 6]


Html markup produced by rfcmarkup 1.122, available from https://tools.ietf.org/tools/rfcmarkup/