[Docs] [txt|pdf] [Tracker] [WG] [Email] [Diff1] [Diff2] [Nits]
Versions: (draft-fujisawa-ip1394-dhcp) 00 01
02 03 RFC 2855
Internet-Draft K. Fujisawa
<draft-ietf-ip1394-dhcp-00.txt> Sony Corporation
Expires: May, 1999 November 1998
DHCP for IEEE 1394
Status of this memo
This document is an Internet-Draft. Internet-Drafts are working
documents of the Internet Engineering Task Force (IETF), its
areas, and its working groups. Note that other groups may also
distribute working documents as Internet-Drafts.
Internet-Drafts are draft documents valid for a maximum of six
months and may be updated, replaced, or obsoleted by other
documents at any time. It is inappropriate to use Internet-
Drafts as reference material or to cite them other than as
``work in progress.''
To view the entire list of current Internet-Drafts, please check
the "1id-abstracts.txt" listing contained in the Internet-Drafts
Shadow Directories on ftp.is.co.za (Africa), ftp.nordu.net
(Northern Europe), ftp.nis.garr.it (Southern Europe), munnari.oz.au
(Pacific Rim), ftp.ietf.org (US East Coast), or ftp.isi.edu
(US West Coast).
Abstract
IEEE Std 1394-1995 is a standard for a High Performance Serial Bus.
Since 1394 uses different link-layer addressing method than
conventional IEEE802/Ethernet, the usage of some fields must be
clarified to achieve interoperability.
This memo describes the 1394 specific usage of some fields of DHCP
messages.
K. Fujisawa Expires May 1999 [Page 1]
Internet Draft draft-ietf-ip1394-dhcp-00.txt November 1998
1. Introduction
IEEE Std 1394-1995 is a standard for a High Performance Serial Bus.
IETF IP1394 Working Group specified the method to carry IPv4
datagrams and ARP packets over an IEEE1394 network [IP1394].
The Dynamic Host Configuration Protocol (DHCP) [RFC2131] provides a
framework for passing configuration information to hosts on a TCP/IP
network.
Since 1394 uses different link-layer addressing method than
conventional IEEE802/Ethernet, the usage of some fields must be
clarified to achieve interoperability.
This memo describes the 1394 specific usage of some fields of DHCP.
See [RFC2131] for the mechanism of DHCP and the explanations of each
fields.
This document is a product of the IP1394 working group within the
Internet Engineering Task Force. Comments are solicited and should
be addressed to the working group's mailing list at
ip1394@mailbag.intel.com and/or the author.
2. 1394 specific usage of DHCP message fields
Following rules should be used when the DHCP client is connected to
an IEEE1394 network.
'htype' (hardware address type) should be 24 [ARPPARAM].
'hlen' (hardware address length) should be 16.
The format of the 'chaddr' (client hardware address) is specified as
follows,
1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| node_ID | unicast_FIFO_hi |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| unicast_FIFO_lo |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| max_rec | spd | reserved |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| reserved |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
The values of 'node_ID', 'unicast_FIFO', 'max_rec' and 'spd' sub-
fields should be the same values used by ARP specified in [IP1394].
A reserved field shall be zeroed. The recipient shall not check the
K. Fujisawa Expires May 1999 [Page 2]
Internet Draft draft-ietf-ip1394-dhcp-00.txt November 1998
value of a reserved field.
NOTE: The usage of the 'node_ID' field is still under discussion
within the working group. According to the discussion for the
virtual node ids in the IEEE P1394.1 Bridges Working Group, a node
in the bridged IEEE1394 buses may have two node_IDs, one physical
node_ID for local bus nodes and one virtual node_ID for remote bus
nodes.
'client identifier' option MUST be used in DHCP messages from the
client to the server due to the transient nature of the 'node_ID'
field in 'chaddr'. 'chaddr' will be used only to return a message
from the server (or DHCP relay-agent) to the client.
'client identifier' option may consist of any data. When an EUI-64
(node unique ID) [EUI64] is used as a 'client identifier', the type
value for the EUI-64 is 27 [ARPPARAM], and the format is illustrated
as follows.
Code Len Type Client-Identifier
+-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+
| 61 | 9 | 27 | EUI-64 (node unique ID) |
+-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+
Note that the use of other 'client identifier' type, such as a fully
qualified domain name (FQDN), is not precluded by this memo.
For more details, see "9.14. Client-identifier" in [RFC2132].
Security Considerations
Security issues are not discussed in this document.
References
[IP1394] P. Johansson, "IPv4 over IEEE 1394",
draft-ietf-ip1394-ipv4-11.txt, work in progress.
[RFC2131] R. Droms, "Dynamic Host Configuration Protocol", RFC2131,
March 1997.
[RFC2132] S. Alexander, R. Droms, "DHCP Options and BOOTP Vendor
Extensions", RFC2132, March 1997.
[EUI64] http://standards.ieee.org/regauth/oui/tutorials/EUI64.html
[ARPPARAM] http://www.isi.edu/in-notes/iana/assignments/arp-parameters
Author's address
K. Fujisawa Expires May 1999 [Page 3]
Internet Draft draft-ietf-ip1394-dhcp-00.txt November 1998
Kenji Fujisawa
Sony Corporation
IT Laboratories, Computer Systems Laboratory
6-7-35, Kitashinagawa,
Shinagawa-ku, Tokyo, 141-0001 Japan
Phone: +81-3-5448-4602
E-mail: fujisawa@sm.sony.co.jp
K. Fujisawa Expires May 1999 [Page 4]
Html markup produced by rfcmarkup 1.129d, available from
https://tools.ietf.org/tools/rfcmarkup/