Network Working Group W. Ladd Internet-Draft UC Berkeley Intended status: Informational B. Kaduk, Ed. Expires: April 19, 2018 Akamai October 16, 2017 SPAKE2, a PAKE draft-irtf-cfrg-spake2-04 Abstract This Internet-Draft describes SPAKE2, a secure, efficient password based key exchange protocol. Status of This Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at https://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." This Internet-Draft will expire on April 19, 2018. Copyright Notice Copyright (c) 2017 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Ladd & Kaduk Expires April 19, 2018 [Page 1]

Internet-Draft SPAKE2, a PAKE October 2017 Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2 2. Definition of SPAKE2 . . . . . . . . . . . . . . . . . . . . 2 3. Table of points for common groups . . . . . . . . . . . . . . 3 4. Security Considerations . . . . . . . . . . . . . . . . . . . 5 5. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 6 6. Acknowledgments . . . . . . . . . . . . . . . . . . . . . . . 6 7. References . . . . . . . . . . . . . . . . . . . . . . . . . 6 Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . 7 1. Introduction This document describes a means for two parties that share a password to derive a shared key. This method is compatible with any group, is computationally efficient, and has a strong security proof. 2. Definition of SPAKE2 2.1. Setup Let G be a group in which the Diffie-Hellman problem is hard of order ph, with p a big prime and h a cofactor. We denote the operations in the group additively. Let H be a hash function from arbitrary strings to bit strings of a fixed length. Common choices for H are SHA256 or SHA512. We assume there is a representation of elements of G as byte strings: common choices would be SEC1 uncompressed [SEC1] for elliptic curve groups or big endian integers of a particular length for prime field DH. || denotes concatenation of strings. We also let len(S) denote the length of a string in bytes, represented as an eight-byte little- endian number. We fix two elements M and N as defined in the table in this document for common groups, as well as a generator G of the group. G is specified in the document defining the group, and so we do not recall it here. Let A and B be two parties. We will assume that A and B are also representations of the parties such as MAC addresses or other names (hostnames, usernames, etc). We assume they share an integer w. Typically w will be the hash of a user-supplied password, truncated and taken mod p. Protocols using this protocol must define the method used to compute w: it may be necessary to carry out normalization. The hashing algorithm SHOULD be designed to slow down brute force attackers. Ladd & Kaduk Expires April 19, 2018 [Page 2]

Internet-Draft SPAKE2, a PAKE October 2017 We present two protocols below. Note that it is insecure to use the same password with both protocols, this MUST NOT be done. 2.2. SPAKE2 A picks x randomly and uniformly from the integers in [0,ph) divisible by h, and calculates X=xG and T=wM+X, then transmits T to B. B selects y randomly and uniformly from the integers in [0,ph), divisible by h and calculates Y=yG, S=wN+Y, then transmits S to A. Both A and B calculate a group element K. A calculates it as x(S-wN), while B calculates it as y(T-wM). A knows S because it has received it, and likewise B knows T. This K is a shared secret, but the scheme as described is not secure. K MUST be combined with the values transmitted and received via a hash function to have a secure protocol. If higher-level protocols prescribe a method for doing so, that SHOULD be used. Otherwise we can compute K' as H(len(A)||A||len(B)||B||len(S)||S|| len(T)||T||len(K)||K || len(w) || w) and use K' as the key. 2.3. SPAKE2+ This protocol and security proof appear in [TDH]. We use the same setup as for SPAKE2, except that we have two secrets, w0 and w1. The server, here Bob, stores L=w1*g and w0. When executing SPAKE2+, A selects x uniformly at random from the numbers in the range [0, ph) divisible by h, and lets X=xG+w0*M, then transmits X to B. B selects y uniformly at random from the numbers in [0, ph) divisible by h, then computes Y=yG+w0*N, and transmits it to Alice. A computes Z as x(Y-w0*N), and V as w1(Y-w0*N). B computes Z as y(X- w0*M) and V as yL. Both share Z and V as common keys. It is essential that both Z and V be used in combination with the transcript to derive the keying material. For higher-level protocols without sufficient transcript hashing, let K' be H(len(A)||A||len(B)||B||len(X)||X||len(Y)||Y||len(Z)||Z||len(V)||V) and use K' as the established key. 3. Table of points for common groups Every curve presented in the table below has an OID from [RFC5480]. We construct a string using the OID and the needed constant, for instance "1.3.132.0.35 point generation seed (M)" for P-512. This Ladd & Kaduk Expires April 19, 2018 [Page 3]

Internet-Draft SPAKE2, a PAKE October 2017 string is turned into an infinite sequence of bytes by hashing with SHA256, and hashing that output again to generate the next 32 bytes, and so on. This pattern is repeated for each group and value, with the string modified appropriately. The initial segment of bytes of length equal to that of an encoded group element is taken, and is then formatted as required for the group. In the case of Weierstrass points, this means setting the first byte to 0x02 or 0x03 depending on the low-order bit. For Ed25519 style formats this means taking all the bytes as the representation of the group element. This string of bytes is then interpreted as a point in the group. If this is impossible, then the next non-overlapping segment of sufficient length is taken. We multiply that point by the cofactor h, and if that is not the identity, output it. These bytestrings are compressed points as in [SEC1] for curves from [SEC1]. For P256: M = 02886e2f97ace46e55ba9dd7242579f2993b64e16ef3dcab95afd497333d8fa12f N = 03d8bbd6c639c62937b04d997f38c3770719c629d7014d49a24b4f98baa1292b49 For P384: M = 030ff0895ae5ebf6187080a82d82b42e2765e3b2f8749c7e05eba366434b363d3dc 36f15314739074d2eb8613fceec2853 N = 02c72cf2e390853a1c1c4ad816a62fd15824f56078918f43f922ca21518f9c543bb 252c5490214cf9aa3f0baab4b665c10 For P521: M = 02003f06f38131b2ba2600791e82488e8d20ab889af753a41806c5db18d37d85608 cfae06b82e4a72cd744c719193562a653ea1f119eef9356907edc9b56979962d7aa N = 0200c7924b9ec017f3094562894336a53c50167ba8c5963876880542bc669e494b25 32d76c5b53dfb349fdf69154b9e0048c58a42e8ed04cef052a3bc349d95575cd25 The following python snippet generates the above points: Ladd & Kaduk Expires April 19, 2018 [Page 4]

Internet-Draft SPAKE2, a PAKE October 2017 def canon_pointstr(self, s): return chr(ord(s[0]) & 1 | 2) + s[1:] def iterated_hash(seed, n): h = seed for i in xrange(n): h = SHA256.new(h).digest() return h def bighash(seed, start, sz): n = -(-sz // 32) hashes = [iterated_hash(seed, i) for i in xrange(start, start + n)] return ''.join(hashes)[:sz] def gen_point(seed, ec, order): for i in xrange(1, 1000): pointstr = ec.canon_pointstr(bighash(seed, i, ec.nbytes_point())) try: p = ec.decode_point(pointstr) if ec.mul(p, order) == ec.identity(): return pointstr, i except Exception: pass 4. Security Considerations A security proof of SPAKE2 for prime order groups is found in [REF]. Note that the choice of M and N is critical for the security proof. The generation method specified in this document is designed to eliminate concerns related to knowing discrete logs of M and N. SPAKE2+ appears in [TDH], along with proof. There is no key-confirmation as this is a one round protocol. It is expected that a protocol using this key exchange mechanism provides key confirmation separately if desired. Elements should be checked for group membership: failure to properly validate group elements can lead to attacks. In particular it is essential to verify that received points are valid compressions of points on an elliptic curve when using elliptic curves. It is not necessary to validate membership in the prime order subgroup: the multiplication by cofactors eliminates this issue. The choices of random numbers MUST BE uniform. Note that to pick a random multiple of h in [0, ph) one can pick a random integer in [0,p) and multiply by h. Reuse of ephemerals results in dictionary attacks and MUST NOT be done. Ladd & Kaduk Expires April 19, 2018 [Page 5]

Internet-Draft SPAKE2, a PAKE October 2017 SPAKE2 does not support augmentation. As a result, the server has to store a password equivalent. This is considered a significant drawback, and so SPAKE2+ also appears in this document. As specified the shared secret K is not suitable for use as a shared key. It MUST be passed to a hash function along with the public values used to derive it and the party identities to avoid attacks. In protocols which do not perform this separately, the value denoted K' MUST be used instead. 5. IANA Considerations No IANA action is required. 6. Acknowledgments Special thanks to Nathaniel McCallum for generation of test vectors. Thanks to Mike Hamburg for advice on how to deal with cofactors. Greg Hudson suggested addition of warnings on the reuse of x and y. Thanks to Fedor Brunner, Adam Langley, and the members of the CFRG for comments and advice. Trevor Perrin informed me of SPAKE2+. 7. References [REF] Abdalla, M. and D. Pointcheval, "Simple Password-Based Encrypted Key Exchange Protocols.", Feb 2005. Appears in A. Menezes, editor. Topics in Cryptography- CT-RSA 2005, Volume 3376 of Lecture Notes in Computer Science, pages 191-208, San Francisco, CA, US. Springer- Verlag, Berlin, Germany. [RFC5480] Turner, S., Brown, D., Yiu, K., Housley, R., and T. Polk, "Elliptic Curve Cryptography Subject Public Key Information", RFC 5480, DOI 10.17487/RFC5480, March 2009, <https://www.rfc-editor.org/info/rfc5480>. [SEC1] SEC, "STANDARDS FOR EFFICIENT CRYPTOGRAPHY, "SEC 1: Elliptic Curve Cryptography", version 2.0", May 2009. [TDH] Cash, D., Kiltz, E., and V. Shoup, "The Twin-Diffie Hellman Problem and Applications", 2008. EUROCRYPT 2008. Volume 4965 of Lecture notes in Computer Science, pages 127-145. Springer-Verlag, Berlin, Germany. Ladd & Kaduk Expires April 19, 2018 [Page 6]

Internet-Draft SPAKE2, a PAKE October 2017 Authors' Addresses Watson Ladd UC Berkeley Email: watsonbladd@gmail.com Benjamin Kaduk (editor) Akamai Technologies Email: kaduk@mit.edu Ladd & Kaduk Expires April 19, 2018 [Page 7]