draft-ietf-dhc-autoconfig-01.txt   draft-ietf-dhc-autoconfig-02.txt 
Dynamic Host Configuration WG R. Troll Dynamic Host Configuration WG R. Troll
Internet Draft: DHC-AUTOCONFIG Carnegie Mellon Internet Draft: DHC-AUTOCONFIG Carnegie Mellon
Document: draft-ietf-dhc-autoconfig-01.txt September 1998 Document: draft-ietf-dhc-autoconfig-02.txt October 1998
Expires: March 1999 Expires: April 1999
DHCP Option to Disable Stateless Auto-Configuration in IPv4 Clients DHCP Option to Disable Stateless Auto-Configuration in IPv4 Clients
<draft-ietf-dhc-autoconfig-01.txt> <draft-ietf-dhc-autoconfig-02.txt>
Status of this memo Status of this memo
This document is an Internet-Draft. Internet-Drafts are working This document is an Internet-Draft. Internet-Drafts are working
documents of the Internet Engineering Task Force (IETF), its areas, documents of the Internet Engineering Task Force (IETF), its areas,
and its working groups. Note that other groups may also distribute and its working groups. Note that other groups may also distribute
working documents as Internet-Drafts. working documents as Internet-Drafts.
Internet-Drafts are draft documents valid for a maximum of six Internet-Drafts are draft documents valid for a maximum of six
months and may be updated, replaced, or obsoleted by other months and may be updated, replaced, or obsoleted by other
skipping to change at page 3, line 32 skipping to change at page 3, line 32
The code for this option is TBD (To Be Determined), and its length The code for this option is TBD (To Be Determined), and its length
is 1. is 1.
This code, along with the IP address assignment, will allow a DHCP This code, along with the IP address assignment, will allow a DHCP
client to determine whether or not it should auto-configure. client to determine whether or not it should auto-configure.
2.1. Auto-Configure Values 2.1. Auto-Configure Values
The auto-configure option uses the following values: The auto-configure option uses the following values:
DoNOTAutoConfigure 1 DoNOTAutoConfigure 0
AutoConfigure 2 AutoConfigure 1
When a server responds with the value "AutoConfigure", the client When a server responds with the value "AutoConfigure", the client
MAY auto-configure if appropriate. However, if the server responds MAY auto-configure if appropriate. However, if the server responds
with "DoNOTAutoConfigure", the client MUST not auto-configure, with "DoNOTAutoConfigure", the client MUST not auto-configure,
possibly leaving it with no IP address. possibly leaving it with no IP address.
2.2. DHCP Client Behavior 2.2. DHCP Client Behavior
Clients that have auto-configuration capabilities MUST add the Clients that have auto-configuration capabilities MUST add the
Auto-Configure option to the list of requested parameters in its Auto-Configure option to the list of requested parameters in its
skipping to change at page 9, line 25 skipping to change at page 9, line 25
Ryan Troll Ryan Troll
Network Development Network Development
Carnegie Mellon Carnegie Mellon
5000 Forbes Avenue 5000 Forbes Avenue
Pittsburgh, PA 15213 Pittsburgh, PA 15213
Phone: (412) 268-8691 Phone: (412) 268-8691
EMail: ryan@andrew.cmu.edu EMail: ryan@andrew.cmu.edu
This document will expire March 1999 This document will expire April 1999
 End of changes. 

This html diff was produced by rfcdiff 1.23, available from http://www.levkowetz.com/ietf/tools/rfcdiff/