Network Working Group Ted Lemon Internet Draft Nominum, Inc. Obsoletes:
draft-ietf-dhc-csr-00.txt March,draft-ietf-dhc-csr-01.txt June, 2000 Expires September 2000January 2001 The Classless Static Route Option for DHCP <draft-ietf-dhc-csr-01.txt><draft-ietf-dhc-csr-02.txt> Status of this Memo This document is an Internet-Draft and is in full conformance with all provisions of Section 10 of RFC2026. This document is an Internet-Draft. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF), its areas, and its working groups. Note that other groups may also distribute working documents as Internet-Drafts. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress". The list of current Internet-Drafts can be accessed at http://www.ietf.org/ietf/1id-abstracts.txt The list of Internet-Draft Shadow Directories can be accessed at http://www.ietf.org/shadow.html. Abstract This document defines a new DHCP option which is passed from the DHCP Server to the DHCP Client to configure a list of static routes in the client. This option supersedes the Static Route option (option 33) defined in . Introduction The IP protocol  uses routers to transmit packets from hosts connected to one IP subnet to hosts connected to a different IP subnet. When an IP host (the source host) wishes to transmit a packet to another IP host (the destination), it first checks to see if the IP address of the destination host to see if it is on a subnet to which the source host is connected. If the destination host's IP address is not on a subnet to which the source host is connected, then the source host consults its routing table to determine the IP address of the router that should be used to forward the packet to the destination host. The routing table on an IP host can be maintained in a variety of ways - using a routing information protocol such as RIP , ICMP router discovery [6,7] or using the DHCP Router option, defined in . In a network that already provides DHCP service, using DHCP to update the routing table on a DHCP client has several virtues. It is efficient, since it makes use of messages that would have been sent anyway. It is convenient - the DHCP server configuration is already being maintained, so maintaining routing information, at least on a relatively stable network, requires little extra work. If DHCP service is already in use, no additional infrastructure need be deployed. The DHCP protocol as defined in  and the options defined in  only provide a mechanism for installing a default route or installing a table of classed routes. Classed routes are routes whose subnet mask is implicit in the subnet number - see section 3.2 of  for details on classed routing. Classed routing is no longer in common use, so the DHCP Static Route option is no longer useful. Currently, classless routing, described in  and , is the most commonly-deployed form of routing on the Internet. In classless routing, IP addresses consist of a network number (the combination of the network number and subnet number described in ) and a host number. In classed IP, the network number and host number are derived from the IP address using a bitmask whose value is determined by the first few bits of the IP address. In classless IP, the network number and host number are derived from the IP address using a seperate quantity, the subnet mask. In order to determine the network to which a given route applies, an IP host must know both the network number AND the subnet mask for that network. The Static Routes option does not provide a subnet mask for each route - it is assumed that the subnet mask is implicit in whatever network number is specified in each route entry. The Classless Static Routes option does provide a subnet mask for each entry, so that the subnet mask can be other than what would be determined using the algorithm specified in  and . Definitions The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY" and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 . This document also uses the following terms: "DHCP client" DHCP client or "client" is an Internet host using DHCP to obtain configuration parameters such as a network address. "DHCP server" A DHCP server or "server" is an Internet host that returns configuration parameters to DHCP clients. Classless Route Option Format The code for this option is TBD, and its minimum length is 5 bytes. This option can contain one or more static routes, each of which consists of a destination descriptor and the IP address of the router that should be used to reach that destination. Code Len Destination 1 Router 1 +-----+---+----+-----+----+----+----+----+----+ | TBD | n | d1 | ... | dN | r1 | r2 | r3 | r4 | +-----+---+----+-----+----+----+----+----+----+ Destination 2 Router 2 +----+-----+----+----+----+----+----+ | d1 | ... | dN | r1 | r2 | r3 | r4 | +----+-----+----+----+----+----+----+ In the above example, two static routes are specified. Destination descriptors describe the IP subnet number and subnet mask of a particular destination using a compact encoding. This encoding consists of one octet describing the width of the subnet mask, followed by all the non-zero octets of the subnet number. The width of the subnet mask describes the number of one bits in the mask, so for example a subnet with a subnet number of 10.0.127.0 and a netmask of 255.255.255.0 would have a subnet mask width of 24. The non-zero portion of the subnet number is simply all of the octets of the subnet number, with the least significant octets that are zero omitted. For a subnet mask width of between 25 and 32, the subnet number will be four octets. Mask widths of between 17 and 24 indicate a three-octet subnet number; between 9 and 16 indicate a two-octet subnet number, between 1 and 8 indicate a one-octet number. As a special case, the default route may be represented by a zero width, with no following subnet number. Host routes are represented by a mask width of 32, followed by four octets containing the IP address of the host. The following table contains some examples: Subnet number Subnet mask Destination descriptor 0 0 0 10.0.0.0 255.0.0.0 8.10 10.17.0.0 255.255.0.0 16.10.17 10.27.129.0 255.255.255.0 220.127.116.11 10.229.0.128 255.255.255.128 18.104.22.168.128 10.198.122.47 255.255.255.255 22.214.171.124.47 DHCP Client Behavior TheDHCP client MAY useclients that do not support this option to installMUST ignore it if it is received from a set of staticDHCP server. DHCP clients that support this option MUST install the routes specified in its routing table. Athe option. DHCP clientclients that implementssupport this option SHOULD useand that send a DHCP Parameter Request List option MUST request both this option and the Routers option  in preference tothe DHCP Parameter Request List. If the DHCP server returns a Routers option, clients that support the Classless Static routesRoutes option if both are presentMUST use the default route(s) listed in a reply fromthe DHCP server. The client MAY request both options.Routers option in addition to the routes listed in the Classless Static Routes option. After deriving a subnet number and subnet mask from each destination descriptor, the DHCP client SHOULD check each route to determine if are any bits in the destination network number whose value is one whose corresponding value in the subnet mask is zero, and SHOULD NOT install any routes for which this is the case. For example, the client should not install a route with a destination of 129.210.377.4 and a subnet mask of 255.255.255.0.255.255.255.128. Because a full routing table can be quite large, the standard 576 octet maximum size for a DHCP message may be too short to contain some legitimate Classless Static Route options. Because of this, clients implementing the Classless Static Route option SHOULD send a Maximum DHCP Message Size  option if the DHCP client's TCP/IP stack is capable of reassembling fragmented IP datagrams. In this case, the client SHOULD set the value of this option to the MTU of the interface that the client is configuring. DHCP Server administrator responsibilities The client's behaviour if both a Routers option and aMany clients may not implement the Classless Static Routes option default route (network number 0.0.0.0, network mask 0.0.0.0) are specified is not defined in this document, so as to avoid placing onerous requirements on the client and server implementations. Therefore, theoption. DHCP server administrator SHOULD NOTadministrators should therefore configure thetheir DHCP server so that it sendsservers to send both a Routers option and a Classless Static Routes option containing a default route. Either no Routers option should be configured (this is probably preferable in the near term, since only newer DHCP clients will implement this option), or the Classless Static Routes optionoption, and should not contain aspecify all default route. The client's behaviour is also not defined in the case where the server sends a classless static route in which some bitsroutes in the network number are 1,Routers option, and corresponding bitsnot specify any default routes in the subnet mask are zero. Therefore, DHCP server administrators SHOULD NOT configure the DHCP server to send such a route.Classless Static Routes option. Security Considerations DHCP currently provides no authentication or security mechanisms. Potential exposures to attack are discussed in section 7 of the DHCP protocol specification . The Classless Static Routes option can be used to misdirect network traffic by providing incorrect IP addresses for routers. References  Droms, R., "Dynamic Host Configuration Protocol", RFC 2131, Bucknell University, March 1997.  Alexander, S. and Droms, R., "DHCP Options and BOOTP Vendor Extensions", RFC 2132, Silicon Graphics, Inc., Bucknell University, March 1997.  Bradner, S., "Key words for use in RFCs to indicate requirement levels", RFC 2119, Harvard University, March 1997.  Postel, J., "Internet Protocol", RFC 791, USC/Information Sciences Institute, September 1981.  Hedrick, C.L., "Routing Information Protocol", RFC 1058, Rutgers University, June 1, 1988.  Deering, S., "ICMP Router Discovery Messages", RFC 1256, Xerox PARC, September 1991.  Postel, J., "Internet Control Message Protocol", RFC 792, USC/Information Sciences Institute, September 1981.  Mogul, J., Postel, J., "Internet Standard Subnetting Procedure", RFC950, Stanford University, USC/Information Sciences Institute, August 1985.  Pummill, T., Manning, B., "Variable Length Subnet Table For IPv4", RFC1878, Alantec, USC/Information Sciences Institute, December, 1995 Author Information Ted Lemon Nominum, Inc. 950 Charter Street Redwood City, CA 94043 email: Ted.Lemon@nominum.com Expiration This document will expire on JulyJanuary 31, 2000.2001. Full Copyright Statement Copyright (C) The Internet Society (2000). All Rights Reserved. This document and translations of it may be copied and furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this paragraph are included on all such copies and derivative works. However, this document itself may not be modified in any way, such as by removing the copyright notice or references to the Internet Society or other Internet organizations, except as needed for the purpose of developing Internet standards in which case the procedures for copyrights defined in the Internet Standards process must be followed, or as required to translate it into languages other than English. The limited permissions granted above are perpetual and will not be revoked by the Internet Society or its successors or assigns. This document and the information contained herein is provided on an "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.