Network Working Group George Swallow Internet Draft Cisco Systems, Inc. Category: Standards Track Expiration Date:
JanuaryMarch 2006 Stewart Bryant Cisco Systems, Inc. Loa Andersson Acreo JulySeptember 2005 Avoiding Equal Cost Multipath Treatment in MPLS Networks draft-ietf-mpls-ecmp-bcp-01.txtdraft-ietf-mpls-ecmp-bcp-02.txt Status of this Memo By submitting this Internet-Draft, each author represents that any applicable patent or other IPR claims of which he or she is aware have been or will be disclosed, and any of which he or she becomes aware will be disclosed, in accordance with Section 6 of BCP 79. This document is an Internet-Draft and is in full conformance with all provisions of Section 5 of RFC3667.Internet-Drafts are working documents of the Internet Engineering Task Force (IETF), its areas, and its working groups. Note that other groups may also distribute working documents as Internet-Drafts.Internet- Drafts. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." The list of current Internet-Drafts can be accessed at http://www.ietf.org/1id-abstracts.html The list of Internet-Draft Shadow Directories can be accessed at http://www.ietf.org/shadow.html Abstract This document describes the Equal Cost Multipath (ECMP) behavior of currently deployed MPLS networks and makes best practice recommendations for anyone defining an application to run over an MPLS network and wishes to avoid such treatment. Contents 1 Introduction .............................................. 3 1.1 Terminology ............................................... 3 2 Current EMCPECMP Practices .................................... 3 3 Recommendations for Avoiding ECMP Treatment ............... 5 4 Security Considerations ................................... 6 5 References ................................................ 6 5.1 Normative References ...................................... 6 6 Authors' Addresses ........................................ 6 1. Introduction This document describes the Equal Cost Multipath (ECMP) behavior of currently deployed MPLS networks and makes best practice recommenda- tions for anyone defining an application to run over an MPLS network and wishes to avoid such treatment. While disabling ECMP behavior is an option open to most operators, few (if any) have chosen to do so. Thus ECMP behavior is a reality that must be reckoned with. 1.1. Terminology ECMP Equal Cost Multipath FEC Forwarding Equivalence Class IP ECMP A forwarding behavior in which the selection of the next-hop between equal cost routes is based on the header(s) of an IP packet Label ECMP A forwarding behavior in which the selection of the next-hop between equal cost routes is based on the label stack of an MPLS packet LSP Label Switched Path LSR Label Switching Router 2. Current EMCPECMP Practices The MPLS label stack and Forwarding Equivalence Classes are defined in [RFC3031]. The MPLS label stack does not carry a Protocol Identi- fier. Instead the payload of an MPLS packet is identified by the Forwarding Equivalence Class (FEC) of the bottom most label. Thus it is not possible to know the payload type if one does not know the label binding for the bottom most label. Since an LSR which is pro- cessing a label stack need only know the binding for the label(s) it must process, it is very often the case that LSRs along an LSP are unable to determine the payload type of the carried contents. As a means of potentially reducing delay and congestion, IP networks have taken advantage of multiple paths through a network by splitting traffic flows across those paths. The general name for this practice is Equal Cost Multipath or ECMP. In general this is done by hashing on various fields on the IP or contained headers. In practice, within a network core, the hashing in based mainly or exclusively on the IP source and destination addresses. The reason for splitting aggregated flows in this manner is to minimize the re-ordering of packets belonging to individual flows contained within the aggregated flow. Within this document we use the term IP ECMP for this type of forwarding algorithm. In the early days of MPLS, the payload was almost exclusively IP. Even today the overwhelming majority of carried traffic remains IP. Providers of MPLS equipment sought to continue this IP ECMP behavior. As shown above, it is not possible to know whether the payload of an MPLS packet is IP at every place where IP ECMP needs to be performed. Thus vendors have taken the liberty of guessing what the payload is. By inspecting the first nibble beyond the label stack, it can be inferred that a packet is not IPv4 or IPv6 if the value of the nibble (where the IP version number would be found) is not 0x4 or 0x6 respectively. Most deployed LSRs will treat a packet whose first nibble is equal to 0x4 as if the payload were IPv4 for purposes of IP ECMP. A consequence of this is that any application which defines a FEC which does not take measures to prevent the values 0x4 and 0x6 from occurring in the first nibble of the payload may be subject to IP ECMP and thus having their flows take multiple paths and arriving with considerable jitter and possibly out of order. While none of this is in violation of the basic service offering of IP, it is detrimental to the performance of various classes of applications. It also complicates the measurement, monitoring and tracing of those flows. New MPLS payload types are emerging such as those specified by the IETF PWE3 and AVT working groups. These payloads are not IP and, if specified without constraint might be mistaken for IP. It must also be noted that LSRs which correctly identify a payload as not being IP, may still need tomost often will load-share thistraffic across multi- plemultiple equal-cost paths. In this case a LABEL ECMP algorithm is employed, where a hash is computedpaths based on all or part(s) ofthe label stack. Any reserved label, no matter where it is located in the stack, may be included in the computationcom- putation for load balancing. Modi- ficationModification of the label stack between packets of a single flow could result in re-ordering that flow. That is, were an explicit null or a router-alert label to be added to a packet, that packet could take a different path through the network. Note that for some applications, being mistaken for IPv4 may not be detrimental. The trivial case where the payload behind the top label is a packet belonging to an MPLS IPv4 VPN. Here the real payload is IP and most (if not all) deployed equipment will locate the end of the label stack and correctly perform IP ECMP. A less obvious case is when the packets of a given flow happen to have constant values in the fields upon which IP ECMP would be per- formed. For example if an ethernet frame immediately follows the label and the LSR does not do ECMP on IPv6, then either the first nibble will be 0x4 or it will be something else. If the nibble is not 0x4 then no IP ECMP is performed, but Label ECMP may be per- formed. If it is 0x4, then the constant values of the MAC addresses overlay the fields that would be occupied by the source and destina- tion addresses of an IP header. 3. Recommendations for Avoiding ECMP Treatment The field inWe will use the figure below taggedterm "Application Label" isto refer to a label of thethat has been allocated with a FEC Type used/definedthat is defined (or simply used) by thean application. It isSuch labels necessarily appear at the bottom most label inof the label stack. As such itsstack, that is, below labels associated with transporting the packet across an MPLS network. The FEC Type of the Application label defines the pay- load whichpayload that follows. Anyone defining an application to be transported over MPLS is free to define new FEC Types and the formatfor- mat of the pay- loadpayload which will be carried. 0 1 2 3 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Label | Exp |0| TTL | MPLS+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ . . . . . . . . . . +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Label | Exp |0| TTL | Label+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Application Label | Exp |1| TTL | Stack+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ |1st Nbl| | Payload+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ In order to avoid IP ECMP treatment it is necessary that an applica- tion take precautions to not be mistaken as IP by deployed equipment that snoops on the presumed location of the IP Version field. Thus, at a minimum, the chosen format must disallow the values 0x4 and 0x6 in the first nibble of their payload. It is strongly recommended, however, that applications restrict the first nibble values to 0x0 and 0x1. This will ensure that that their traffic flows will not be affected if some future routing equipment does similar snooping on some future version of IP. 4. Security Considerations This memo documents current practices. As such it creates no new security considerations. 5. References 5.1. Normative References [RFC3031] Rosen, E. et al., "Multiprotocol Label Switching Architecture", January 2001. 6. Authors' Addresses Loa Andersson Acreo Email: email@example.com Stewart Bryant Cisco Systems 250, Longwater, Green Park, Reading, RG2 6GB, UK Email: firstname.lastname@example.org George Swallow Cisco Systems, Inc. 1414 Massachusetts Ave Boxborough, MA 01719 Email: email@example.com Copyright Notice Copyright (C) The Internet Society (2005). This document is subject to the rights, licenses and restrictions contained in BCP 78, and except as set forth therein, the authors retain all their rights. Expiration Date JanuaryMarch 2006 Disclaimer of Validity This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFOR- MATIONINFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. The IETF takes no position regarding the validity or scope of any Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the procedures with respect to rights in RFC documents can be found in BCP 78 and BCP 79. Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at http://www.ietf.org/ipr. The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at firstname.lastname@example.org.