draft-ietf-mpls-ldp-07.txt   draft-ietf-mpls-ldp-08.txt 
skipping to change at page 1, line 21 skipping to change at page 1, line 21
Andre Fredette Andre Fredette
Nortel Networks Inc. Nortel Networks Inc.
Bob Thomas Bob Thomas
Cisco Systems, Inc. Cisco Systems, Inc.
June 2000 June 2000
LDP Specification LDP Specification
draft-ietf-mpls-ldp-07.txt draft-ietf-mpls-ldp-08.txt
Status of this Memo Status of this Memo
This document is an Internet-Draft and is in full conformance with This document is an Internet-Draft and is in full conformance with
all provisions of Section 10 of RFC2026. all provisions of Section 10 of RFC2026.
Internet-Drafts are working documents of the Internet Engineering Internet-Drafts are working documents of the Internet Engineering
Task Force (IETF), its areas, and its working groups. Note that Task Force (IETF), its areas, and its working groups. Note that
other groups may also distribute working documents as Internet- other groups may also distribute working documents as Internet-
Drafts. Drafts.
skipping to change at page 41, line 13 skipping to change at page 41, line 13
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Res Res
This field is reserved. It must be set to zero on transmission and This field is reserved. It must be set to zero on transmission and
must be ignored on receipt. must be ignored on receipt.
Len Len
This field specifies the number of bits of the DLCI. The following This field specifies the number of bits of the DLCI. The following
values are supported: values are supported:
0 = 10 bits DLCI 0 = 10 bits DLCI
1 = 17 bits DLCI
2 = 23 bits DLCI 2 = 23 bits DLCI
Len values 1 and 3 are reserved.
DLCI DLCI
The Data Link Connection Identifier. Refer to [FR] for the label The Data Link Connection Identifier. Refer to [FR] for the label
values and formats. values and formats.
3.4.3. Address List TLV 3.4.3. Address List TLV
The Address List TLV appears in Address and Address Withdraw The Address List TLV appears in Address and Address Withdraw
messages. messages.
Its encoding is: Its encoding is:
skipping to change at page 65, line 41 skipping to change at page 65, line 41
This field is reserved. It must be set to zero on This field is reserved. It must be set to zero on
transmission and ignored on receipt. transmission and ignored on receipt.
Len Len
This field specifies the number of bits of the DLCI. The This field specifies the number of bits of the DLCI. The
following values are supported: following values are supported:
Len DLCI bits Len DLCI bits
0 10 0 10
1 17
2 23 2 23
Len values 1 and 3 are reserved.
Minimum DLCI Minimum DLCI
This 23-bit field specifies the lower bound of a block of This 23-bit field specifies the lower bound of a block of
Data Link Connection Identifiers (DLCIs) that is supported on Data Link Connection Identifiers (DLCIs) that is supported on
the originating switch. The DLCI should be right justified the originating switch. The DLCI should be right justified
in this field and unused bits should be set to 0. in this field and unused bits should be set to 0.
Maximum DLCI Maximum DLCI
This 23-bit field specifies the upper bound of a block of This 23-bit field specifies the upper bound of a block of
Data Link Connection Identifiers (DLCIs) that is supported on Data Link Connection Identifiers (DLCIs) that is supported on
 End of changes. 

This html diff was produced by rfcdiff 1.23, available from http://www.levkowetz.com/ietf/tools/rfcdiff/