--- 1/draft-ietf-roll-home-routing-reqs-04.txt	2008-11-19 20:12:05.000000000 +0100
+++ 2/draft-ietf-roll-home-routing-reqs-05.txt	2008-11-19 20:12:05.000000000 +0100
@@ -1,19 +1,19 @@
 Networking Working Group                                      A. Brandt
 Internet Draft                                             Zensys, Inc.
 Intended status: Informational                                 G. Porcu
-Expires: January 2009                                    Telecom Italia
-                                                       October 24, 2008
+Expires: May 2009                                        Telecom Italia
+                                                      November 19, 2008
 
        Home Automation Routing Requirements in Low Power and Lossy
                                 Networks
-                  draft-ietf-roll-home-routing-reqs-04
+                  draft-ietf-roll-home-routing-reqs-05
 
 Status of this Memo
 
    By submitting this Internet-Draft, each author represents that
    any applicable patent or other IPR claims of which he or she is
    aware have been or will be disclosed, and any of which he or she
    becomes aware will be disclosed, in accordance with Section 6 of
    BCP 79.
 
    Internet-Drafts are working documents of the Internet Engineering
@@ -26,21 +26,21 @@
    documents at any time. It is inappropriate to use Internet-Drafts
    as reference material or to cite them other than as "work in
    progress."
 
    The list of current Internet-Drafts can be accessed at
    http://www.ietf.org/ietf/1id-abstracts.txt
 
    The list of Internet-Draft Shadow Directories can be accessed at
    http://www.ietf.org/shadow.html
 
-   This Internet-Draft will expire on April 24, 2009.
+   This Internet-Draft will expire on May 19, 2009.
 
 Copyright Notice
 
    Copyright (C) The IETF Trust (2008).
 
 Abstract
 
    This document presents home control and automation application
    specific requirements for Routing Over Low power and Lossy
    networks (ROLL). In a modern home, a high number of wireless
@@ -627,28 +627,20 @@
    period with no movement has elapsed. The highest transmission
    frequency depends on the idle period used in the sensor.
    Sometimes, a timer will trigger a frame transmission when an
    extended period without status change has elapsed.
 
    All frames sent in the above examples are quite short, typically
    less than 5 bytes of payload. Lost frames and interference from
    other transmitters may lead to retransmissions. In all cases,
    acknowledgment frames with a size of a few bytes are used.
 
-5. Open Issues
-
-   Other items to be addressed in further revisions of this document
-   include:
-
-   o  Load Balancing (Symmetrical and Asymmetrical)
-   o  Use case: Home Control Installer Scenario
-
 6. Security Considerations
 
    Implementing security mechanisms in ROLL network devices may
    degrade energy efficiency and increase cost.
 
    The routing protocol chosen for ROLL MUST allow for low-power,
    low-cost network devices with limited security needs.
 
    Protection against unintentional inclusion in neighboring networks
    MUST be provided.
@@ -672,31 +664,52 @@
    are developed in parallel to this document.
 
    When promoted to an RFC, the references MUST be updated to RFCs as
    well or removed from the references section.
 
 9.1. Normative References
 
    [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
              Requirement Levels", BCP 14, RFC 2119, March 1997.
 
-   draft-ietf-roll-indus-routing-reqs-01.txt
-
-   draft-ietf-roll-urban-routing-reqs-01.txt
+9.2. Informative References
 
-   draft-martocci-roll-commercial-routing-reqs-00.txt
+   [I-D.draft-ietf-roll-indus-routing-reqs]
+              "Industrial Routing Requirements in Low Power and Lossy
+              Networks", Kris Pister, Pascal Thubert, Sicco Dwars,
+              Tom Phinney, draft-ietf-roll-indus-routing-reqs-02
+              (work in progress), October 2008
 
-   draft-ietf-roll-protocols-survey-00.txt
+   [I-D.draft-ietf-roll-urban-routing-reqs]
+              "Urban WSNs Routing Requirements in Low Power and Lossy
+              Networks", Mischa Dohler, Thomas Watteyne, Tim Winter,
+              Dominique Barthel, Christian Jacquenet,
+              Giyyarpuram Madhusudan, Gabriel Chegaray,
+              draft-ietf-roll-urban-routing-reqs-02 (work in progress)
+              October 2008
 
-   draft-vasseur-roll-terminology-02.txt
+   [I-D.draft-martocci-roll-building-routing-reqs]
+             "Building Automation Routing Requirements in Low Power
+             and Lossy Networks", Jerry Martocci, Nicolas Riou,
+             Pieter Mil, Wouter Vermeylen,
+             draft-martocci-roll-building-routing-reqs-01
+             (work in progress), October 2008
 
-9.2. Informative References
+   [I-D.draft-martocci-roll-commercial-routing-reqs]
+             "Commercial Routing Requirements in Low Power and
+             Lossy Networks", Jerry Martocci, Ted Humpal, Nicolas Riou,
+             Jon Williamsson,
+             draft-martocci-roll-commercial-routing-reqs-00.txt
+   [I-D.draft-vasseur-roll-terminology]
+             "Terminology in Low power And Lossy Networks",
+             JP Vasseur, draft-ietf-roll-terminology-00
+             (work in progress), October 2008
 
 Author's Addresses
 
    Anders Brandt
    Zensys, Inc.
    Emdrupvej 26
    Copenhagen, DK-2100
    Denmark
 
    Email: abr@zen-sys.com