draft-ietf-roll-home-routing-reqs-05.txt		draft-ietf-roll-home-routing-reqs-06.txt
	Networking Working Group A. Brandt		Networking Working Group A. Brandt
	Internet Draft Zensys, Inc.		Internet Draft Zensys, Inc.
	Intended status: Informational G. Porcu		Intended status: Informational G. Porcu
	Expires: May 2009 Telecom Italia		Expires: May 2009 Telecom Italia
	November 19, 2008		November 19, 2008
	Home Automation Routing Requirements in Low Power and Lossy		Home Automation Routing Requirements in Low Power and Lossy
	Networks		Networks
	draft-ietf-roll-home-routing-reqs-05		draft-ietf-roll-home-routing-reqs-06
	Status of this Memo		Status of this Memo
	By submitting this Internet-Draft, each author represents that		By submitting this Internet-Draft, each author represents that
	any applicable patent or other IPR claims of which he or she is		any applicable patent or other IPR claims of which he or she is
	aware have been or will be disclosed, and any of which he or she		aware have been or will be disclosed, and any of which he or she
	becomes aware will be disclosed, in accordance with Section 6 of		becomes aware will be disclosed, in accordance with Section 6 of
	BCP 79.		BCP 79.
	Internet-Drafts are working documents of the Internet Engineering		Internet-Drafts are working documents of the Internet Engineering
	skipping to change at page 4, line 51		skipping to change at page 4, line 51
	event.		event.
	The sensor may generate a trap message to notify a		The sensor may generate a trap message to notify a
	controller or directly activate an actuator.		controller or directly activate an actuator.
	If sufficiently powered, sensor nodes may		If sufficiently powered, sensor nodes may
	participate in routing network messages.		participate in routing network messages.
	Upstream: Data direction traveling from a PAN to a LAN		Upstream: Data direction traveling from a PAN to a LAN
	device.		device.
	Refer to the roll-terminology reference document for a full list		Refer to the roll-terminology reference document for a full list
	of terms used in the IETF ROLL WG.		of terms used in the IETF ROLL WG (I-D.draft-ietf-roll-terminology).
	1. Introduction		1. Introduction
	This document presents home control and automation application		This document presents home control and automation application
	specific requirements for Routing Over Low power and Lossy		specific requirements for Routing Over Low power and Lossy
	networks (ROLL). In a modern home, a high number of wireless		networks (ROLL). In a modern home, a high number of wireless
	devices are used for a wide set of purposes. Examples include		devices are used for a wide set of purposes. Examples include
	actuators (relay, light dimmer, heating valve), sensors (wall		actuators (relay, light dimmer, heating valve), sensors (wall
	switch, water leak, blood pressure) and advanced controllers.		switch, water leak, blood pressure) and advanced controllers.
	Basic home control modules such as wall switches and plug-in		Basic home control modules such as wall switches and plug-in
	skipping to change at page 16, line 7		skipping to change at page 16, line 7
	When promoted to an RFC, the references MUST be updated to RFCs as		When promoted to an RFC, the references MUST be updated to RFCs as
	well or removed from the references section.		well or removed from the references section.
	9.1. Normative References		9.1. Normative References
	[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate		[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
	Requirement Levels", BCP 14, RFC 2119, March 1997.		Requirement Levels", BCP 14, RFC 2119, March 1997.
	9.2. Informative References		9.2. Informative References
	[I-D.draft-ietf-roll-indus-routing-reqs]		[I-D.draft-ietf-roll-terminology]
	"Industrial Routing Requirements in Low Power and Lossy
	Networks", Kris Pister, Pascal Thubert, Sicco Dwars,
	Tom Phinney, draft-ietf-roll-indus-routing-reqs-02
	(work in progress), October 2008
	[I-D.draft-ietf-roll-urban-routing-reqs]
	"Urban WSNs Routing Requirements in Low Power and Lossy
	Networks", Mischa Dohler, Thomas Watteyne, Tim Winter,
	Dominique Barthel, Christian Jacquenet,
	Giyyarpuram Madhusudan, Gabriel Chegaray,
	draft-ietf-roll-urban-routing-reqs-02 (work in progress)
	October 2008
	[I-D.draft-martocci-roll-building-routing-reqs]
	"Building Automation Routing Requirements in Low Power
	and Lossy Networks", Jerry Martocci, Nicolas Riou,
	Pieter Mil, Wouter Vermeylen,
	draft-martocci-roll-building-routing-reqs-01
	(work in progress), October 2008
	[I-D.draft-martocci-roll-commercial-routing-reqs]
	"Commercial Routing Requirements in Low Power and
	Lossy Networks", Jerry Martocci, Ted Humpal, Nicolas Riou,
	Jon Williamsson,
	draft-martocci-roll-commercial-routing-reqs-00.txt
	[I-D.draft-vasseur-roll-terminology]
	"Terminology in Low power And Lossy Networks",		"Terminology in Low power And Lossy Networks",
	JP Vasseur, draft-ietf-roll-terminology-00		JP Vasseur, draft-ietf-roll-terminology-00
	(work in progress), October 2008		(work in progress), October 2008
	Author's Addresses		Author's Addresses
	Anders Brandt		Anders Brandt
	Zensys, Inc.		Zensys, Inc.
	Emdrupvej 26		Emdrupvej 26
	Copenhagen, DK-2100		Copenhagen, DK-2100
End of changes. 3 change blocks.
	29 lines changed or deleted		3 lines changed or added
This html diff was produced by rfcdiff 1.35. The latest version is available from http://tools.ietf.org/tools/rfcdiff/